Unfortunately, there is no out of the box switch case in Mendix.
However, if you base your case value on an enumeration-value then you can set the expression of the exclusive split value to the enumeration value. This will change your available outcomes to the different enumeration values.
Hope it helps
If i understood the question correctly, one way is to > create ENUM with 5 values and Pass it to “Decision” as expression and proceed to execute microflows based on condition values. like below
Use an Exclusive Split activity to define conditions for each case and connect them to respective microflows. Pass necessary parameters and implement specific logic in each microflow. This allows you to route the flow based on conditions, simulating a switch case behavior.